During the AIP Publishing Horizons- Energy Storage and Conversion virtual conference, which will be held between Aug 4-6, Andrew Shore and Behrang Hamadani, from the National Institute of Standards and Technology, will present their findings on the capabilities of indoor solar cells in generating power under an LED.
Their presentation, "Indoor photovoltaics for battery-powered sensors," will be available during the three-day conference.
The researchers used one lighting source, a white LED with a colour coordinate temperature of 3,000 K and illuminance of 1,000 lux, akin to normal brightness for indoor lights, to test three different modules- a gallium indium phosphide (GaInP) semiconductor, a gallium arsenide (GaAs) semiconductor, and silicon (Si) semiconductor.
The light source peaked in intensity on the shorter wavelengths of light.
"Under these light settings, the GaInP mini-module performed with the highest power conversion efficiency, followed by the GaAs mini-module, with the Si mini-module as the lowest performer," Shore said.
Shore added, "The GaInP and GaAs modules have a better spectral match with this visible-spectrum LED light source."
Since there is usually plenty of indoor ambient light from different sources, a ceiling light in an office environment would be enough to charge any of the mini-modules that were tested, making them all viable as power sources for indoor batteries and sensors.
Shore said the GaInP would require the least amount of light and still maintain high efficiency, but not all indoor light sources are LEDs.
"Different light sources have different spectra," he said adding, "For instance, an incandescent light source has a large portion of its irradiance in the near-infrared region. Fluorescent lights have several spikes in intensity at different places in the visible spectrum. LED lights generally have one short, prominent peak around 450 nanometers and another more gradual peak around 600 nm. Each of these light sources will affect the power conversion efficiency of the photovoltaic technology."
Shore said the next step will be testing the mini-modules under real-world conditions, like a person turning a light on and off at regular intervals. They hope to operate more than one sensor being powered by a module during that testing.
Washington, August 4
As more of our devices require recharging of their batteries, researchers are looking to ambient lighting as a potential source of generating small amounts of power for indoor devices.
Disclaimer: This story was supplied by an external content provider; we do not endorse or accept responsibility for its accuracy, completeness, or any outcomes from relying on it. It is for informational purposes only and does not constitute legal, financial, medical, or other professional advice. Laws and regulations vary and may change; readers should verify accuracy and compliance with local requirements and consult a qualified professional for tailored guidance.
